[Milkymist-devel] Install driver for Xilinx Cable USB II
adam at sharism.cc
Tue Nov 16 18:33:12 PST 2010
> http://www.xilinx.com/support/answers/29310.htm (and specifically NOTE 3)
> You should have the file xusbdfwu.rules in /etc/udev/rules.d/ and the .hex
> in /usr/share.
yes, i did follow manually xusbdfwu.rules copied from
and all xusb*.hex files from /ISE_install_dir/bin/lin/xusb*.hex
These instructions in readme.txt from
Place the .hex files in /usr/share and the .rule in /etc/udev/rules.d.
> Then the cable's LED should be ON when you plug it, and the cable should
> in impact (without any further setup).
Before copied your all files, my all files have been existed there except
"85-xusbdfwu.rules". BTW, after overwrote all files, now my two JTAG cables
<before ID 03fd:0007, 03fd:0013> is all became <ID 03fd:0008>, and LED
light up when plug it.
While initialing iMPACT, it indeed still complains about missing windrv6...
WARNING:iMPACT - Module parport_pc is not loaded. Please reinstall the
cable drivers. See Answer Record 22648.
Cable connection failed.
PROGRESS_END - End Operation.
Elapsed time = 11 sec.
Cable autodetection failed.
WARNING:iMPACT:923 - Can not find cable, check cable setup !
Next go directly to see if cable actually works regardless of impact console
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the Devel