[Milkymist-devel] Datasheets

[Sébastien Bourdeauducq]

Hi,

On Thursday 03 December 2009 09:37:49 Johan Euphrosine wrote:
> I used gschem (for the first time) to draw ADV7181BBSTZ schematic from
> the following datasheet:
> http://github.com/lekernel/milkymist-datasheets/raw/master/VideoIn/ADV7181B
> .pdf
> 
> Feel free to review it for inclusion in http://www.gedasymbols.org/

Pin numbers are correct.
Just a little remark: the bar on top of some signals (for example: RESET) 
denotes active-low signals (for example: the chip is reset when the RESET 
signal is 0, not 1 as it would be with an active-high signal). It is good to 
include that in the schematics symbol as well, for example by appending "#" or 
"_N" to the signal name (RESET#, RESET_N).

Sébastien